☎ 0406 776 186
Get a Free Quote
Custom and pre-fab steel fencing, fabricated to fit your boundary — not adjusted on-site to make a standard panel work.
Adonai Steel Fabrications builds both fully custom steel fencing — fabricated panel by panel to match a specific site, slope or design — and pre-fabricated steel fencing for straightforward boundary runs, at a lower cost than a full custom build. Which one suits depends on your site’s slope, your street-frontage rules, and whether you need pool-compliant fencing.
A selection of recent fencing jobs across Melbourne’s East — every one measured on site and fabricated to fit.
Fabricated to fit, by a local shop.
15+ years fabricating steel fencing across Melbourne’s East, on flat blocks and difficult sloped sites alike.
Custom and pre-fab options, so you’re not paying for full customisation on a straightforward boundary run.
Fencing designed to match your gates and balustrades, not as a separate, disconnected job.
Proud member of Master Builders Victoria.
If your boundary is a straight run on level ground, pre-fab steel fencing gets the job done at a lower cost. If your site slopes, has an irregular boundary line, needs to match an existing custom gate, or sits on a prominent street frontage where the fence is part of the presentation, custom fabrication is worth the extra step — it’s built panel-by-panel to the actual site rather than adjusted after the fact.
Prefer a factory colour finish with less upkeep? See our Colorbond page — similar fabrication, different material and finish.
We measure your boundary on-site, noting slope, existing structures and council requirements.
We recommend custom or pre-fab fencing based on your site, and confirm the panel style.
We fabricate and install, matching any gates or balustrades on the same property.
Pre-fabricated steel fencing uses standard panel sizes suited to straight, level boundary runs, while custom steel fencing is fabricated to the specific dimensions and slope of your site — the right choice depends on how regular your boundary line is and whether it needs to match existing gates or balustrades.
Yes — when fencing and gates are on the same property, we design the panel style and finish together so the fence line and gate match rather than looking like two separate jobs.
[PLACEHOLDER — typical turnaround from measure-up to fabrication and installation. We’ll confirm a realistic timeframe with the client before this goes live.]
Tell us what you need and we’ll come back with a straightforward quote — no call centre, no guesswork.